Connectivity Guide

Congure anycast gateway IP address
OOS10(config-if-vn)# ip virtual-router address 10.1.0.100
VTEP 2 Leaf Switch
1. Congure the underlay OSPF protocol
Do not congure the same router ID on other VTEP switches.
OS10(config)# router ospf 1
OS10(config-router-ospf-1)# router-id 22.1.1.1
OS10(config-router-ospf-1)# exit
2. Congure a loopback interface
The source-interface IP address must be same as the source-interface IP address on the VLT peer.
OS10(config)# interface loopback0
OS10(conf-if-lo-0)# no shutdown
OS10(conf-if-lo-0)# ip address 31.1.1.1/32
OS10(conf-if-lo-0)# ip ospf 1 area 0.0.0.0
OS10(conf-if-lo-0)# exit
3. Congure the loopback interface as the VXLAN source tunnel interface
OOS10(config)# nve
OS10(config-nve)# source-interface loopback0
OS10(config-nve)# exit
4. Congure a VXLAN virtual network with a static VTEP
OS10(config)# virtual-network 10000
OS10(config-vn)# vxlan-vni 100
OS10(config-vn-vxlan-vni-100)# remote-vtep 32.1.1.1
OS10(config-vn-vxlan-vni-100)# exit
OS10(config-vn)# exit
5. Assign switch-scoped VLAN to a virtual network
OS10(config)# interface vlan100
OS10(config-if-vl-100)# virtual-network 10000
OS10(config-if-vl-100)# no shutdown
OS10(config-if-vl-100)# exit
6. Congure access ports as VLAN members
OS10(config)# interface port-channel10
OS10(conf-if-po-10)# no shutdown
OS10(conf-if-po-10)# switchport mode trunk
OS10(conf-if-po-10)# switchport trunk allowed vlan 100
OS10(conf-if-po-10)# exit
OS10(config)# interface ethernet1/1/5
OS10(conf-if-eth1/1/5)# no shutdown
OS10(conf-if-eth1/1/5)# channel-group 10 mode active
OS10(conf-if-eth1/1/5)# no switchport
OS10(conf-if-eth1/1/5)# exit
OS10(config)# interface port-channel20
OS10(conf-if-po-20)# no shutdown
OS10(conf-if-po-20)# switchport access vlan 100
OS10(conf-if-po-20)# exit
OS10(config)# interface ethernet1/1/6
VXLAN
541