Connectivity Guide

Usage Information Use this command to congure a range of IPv4 or IPv6 addresses.
Example
OS10(config-dhcp-Dell)# network 20.1.1.1/24
Supported Releases 10.2.0E or later
pool
Creates an IP address pool name.
Syntax
pool pool-name
Parameters pool-name — Enter the DHCP server pool name.
Default Not congured
Command Mode CONFIGURATION
Usage Information Use this command to create an IP address pool name.
Example
OS10(conf-dhcp)# pool Dell
OS10(conf-dhcp-Dell)#
Supported Releases 10.2.0E or later
range
Congures a range of IP addresses.
Syntax
range {ip-address1 [ip-address2]}
Parameters
• ip-address1—First IP address of the IP address range.
• ip-address2—Last IP address of the IP address range.
Default Not congured
Command Mode DHCP-POOL
Usage Information This command is used to congure a range of IP addresses that the OS10 switch, acting as the DHCP server, can
assign to DHCP clients. The no version of this command requires only the rst IP address to remove the range
conguration.
Example
OS10(config)# OS10(config)# ip dhcp server
OS10(config-dhcp)# pool pool1
OS10(config-dhcp-pool1)# network 192.168.10.0/24
OS10(config-dhcp-pool1)# range 192.168.10.2 192.168.10.8
Supported Releases 10.4.1 or later
show ip dhcp binding
Displays the DHCP binding table with IPv4 addresses.
Syntax
show ip dhcp binding
Parameters None
594 System management