Connectivity Guide

• icmp — (Optional) Enter the ICMP address to deny.
• ipv6 — (Optional) Enter the IPv6 address to deny.
• tcp — (Optional) Enter the TCP address to deny.
• udp — (Optional) Enter the UDP address to deny.
• A::B — Enter the IPv6 address in dotted decimal format.
• A::B/x — Enter the number of bits to match to the IPv6 address.
• any — (Optional) Enter so that all routes are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ipv6-address — (Optional) Enter the keyword and the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny ipv6 any any capture session 1
Supported Releases 10.2.0E or later
deny (MAC)
Congures a lter to drop packets with a specic MAC address.
Syntax
deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn
[00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan]
Parameters
• nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets are sent.
• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of
00:00:00:00:00:00 applies.
• any — (Optional) Set routes which are subject to the lter.
– protocol-number — (Optional) MAC protocol number identied in the header, from 600 to .
– capture — (Optional) Capture packets the lter processes.
– cos — (Optional) CoS value, from 0 to 7.
– vlan — (Optional) VLAN number, from 1 to 4093.
Default Disabled
Command Mode MAC-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# deny any any cos 7
OS10(conf-mac-acl)# deny any any vlan 2
Supported Releases 10.2.0E or later
712 Access Control Lists