Connectivity Guide

| |ISCSI_COS | | 10 |
---------------------------------------------------------------
Command Mode CONFIG
Usage Information
After you run this command, enter the write memory and reload commands to save the changes and to
reboot the switch.
The no form of this command removes the user-dened prole and applies the default ACL table prole to the
switch. Again, you must run the
write memory and reload commands for the changes to take eect.
Example
OS10(config)# hardware acl-table-profile V4-USER-SCALE
OS10(config)# exit
OS10# write memory
OS10# reload
Supported Releases 10.4.2.1 and later
ingress app-group
Denes the number of hardware pools for each of the application groups, and the amount of space to be reserved for each of the features
within the application group.
Syntax
• ingress app-group-1 pool-count count [L2-USER-ACL shared]
• ingress app-group-2 pool-count count [L2-QOS-ACL shared]
• ingress app-group-3 pool-count count [IPV4-USER-ACL {shared | max {reserved
percentage}} IPv6-USER-ACL {shared | max {reserved percentage}}]
• ingress app-group-4 pool-count count [ISCSI-SNOOP-ACL {max {reserved
percentage}} IPV4-PBR-ACL {shared | max {reserved percentage}} IPV6-PBR-ACL
{shared | max {reserved percentage}}]
• ingress app-group-5 pool-count count [IPV4-QOS-ACL {max {reserved
percentage}} IPV6-QOS-ACL {shared | max {reserved percentage}} ISCSI-COS-ACL
{max {reserved percentage}}]
Parameters
• count — Number of hardware pools you want to allocate for the particular application group:
– app-group-1 — from 1 to 5
– app-group-2 — from 0 to 4
– app-group-3 — from 0 to 4
– app-group-4 — from 0 to 4
– app-group-5 — from 0 to 4
• shared — Enter the shared keyword if you want the ACL table space to be shared among the features
within the application group.
Using the shared keyword implies that you do not explicitly reserve space for the features that share the
same group. Instead, the ACL rules are allocated space in the pool on a rst come-rst serve basis. For
example, when you congure app-group-3 and choose to share the pool space between the IPv4-USER-ACL
and IPv6-USER-ACL features, the pool space could be shared between the two features, or used up by either
IPv4-USER-ACLs or IPV6-USER-ACLs, depending on whichever entries are added rst.
• max — Enter the max keyword and specify the percentage of dedicated space that you want to allocate for
each of the features within the application group.
• reserved percentage — Enter percentage in multiples of ve.
Access Control Lists 719