Connectivity Guide

– dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# permit icmp any any capture session 1
Supported Releases 10.2.0E or later
permit ip
Congures a lter to permit all or specic packets from an IPv4 address.
Syntax
permit ip [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D | A.B.C.D/x |
any | host ip-address] [capture | dscp | fragments]
Parameters
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits to match to the dotted decimal address.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
– fragments — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(conf-ipv4-acl)# permit ip any any capture session 1
Supported Releases 10.2.0E or later
permit ipv6
Congures a lter to permit all or specic packets from an IPv6 address.
Syntax
permit ipv6 [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any |
host ipv6-address] [capture| dscp | fragment]
Parameters
• A::B — (Optional) Enter the source IPv6 address from which the packet was sent and the destination
address.
• A::B/x — (Optional) Enter the source network mask in /prex format (/x) and the destination mask.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Enter to capture packets the lter processes.
Access Control Lists 733