Connectivity Guide

• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information The no version of this command removes the lter, or use the no seq sequence-number command if you
know the lter’s sequence number.
Example
OS10(config)# ip access-list egress
OS10(config-ipv4-acl)# seq 10 deny ip any any capture session 1
Supported Releases 10.2.0E or later
seq deny ipv6
Assigns a lter to deny IPv6 addresses while creating the lter.
Syntax
seq sequence-number deny ip [A::B | A::B/x | any | host ipv6-address] [A::B |
A:B/x | any | host ipv6-address] [capture | dscp value | fragment]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information The no version of this command removes the lter, or use the no seq sequence-number command if you
know the lter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 deny ipv6 any any capture session 1
Supported Releases 10.2.0E or later
Access Control Lists 741