Connectivity Guide

On a S4148U-ON switch, FC interfaces are available in all port groups. The activated FC interfaces depend on the currently congured port
prole. For more information, see S4148U-ON port proles.
Figure 2. S4148U-ON unied port groups
1 Congure a unied port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the switch.
port-group node/slot/port-group
2 Activate the unied port group for FC operation in PORT-GROUP mode. The available FC modes depend on the switch.
mode fc {32g-4x | 32g-2x | 32g-1x | 16g-4x | 16g-2x | 8g-4x}
• 8g-4x — Split a unied port group into four 8 GFC interfaces.
• 16g-2x — Split a unied port group into two 16 GFC interfaces.
• 16g-4x — Split a unied port group into four 16 GFC interfaces.
• 32g-1x — Split a unied port group into one 32 GFC interface. A 1x-32G interface has a rate limit of 28G.
• 32g-2x — Split a unied port group into two 32 GFC interfaces.
• 32g-4x — Split a unied port group into four 32 GFC interfaces. Each 4x-32GE breakout interface has a rate limit of 25G.
3 Return to CONFIGURATION mode.
exit
4 Enter FC Interface mode to enable data transmission. Enter a single interface, a hyphen-separated range, or multiple interfaces
separated by commas.
interface fibrechannel node/slot/port[:subport]
5 (Optional) Recongure the interface speed in INTERFACE mode.
speed {8 | 16 | 32 | auto}
6 Enable the FC interface in INTERFACE mode.
no shutdown
Congure FC interface
OS10(config)# port-group 1/1/15
OS10(conf-pg-1/1/15)# mode FC 16g-4x
OS10(conf-pg-1/1/15)# exit
OS10(config)# interface fibrechannel 1/1/43:1
OS10(conf-if-fc-1/1/43:1)# speed 32
OS10(conf-if-fc-1/1/43:1)# no shutdown
View FC interface
OS10(config)# interface fibrechannel 1/1/43:1
OS10(conf-if-fc-1/1/43:1)# show configuration
!
interface fibrechannel1/1/43:1
no shutdown
speed 32
vfabric 100
OS10# show interface fibrechannel 1/1/43:1
Fibrechannel 1/1/43:1 is up, FC link is up
Address is 14:18:77:20:8d:fc, Current address is 14:18:77:20:8d:fc
Interfaces
87