Connectivity Guide

Table Of Contents
Usage Information
The no version of this command to disables sFlow.
Example (interface)
OS10(config)# sflow enable
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# sflow enable
Example (interface
range)
OS10(config)# sflow enable
OS10(config)# interface range ethernet 1/1/1-1/1/10
OS10(conf-range-eth1/1/1-1/1/10)# sflow enable
Example (port-
channel)
OS10(config)# sflow enable
OS10(config)# interface range port-channel 1-10
OS10(conf-range-po-1-10)# sflow enable
Supported Releases 10.3.0E or later
sow max-header-size
Sets the maximum header size of a packet.
Syntax
sflow max-header-size header-size
Parameter header-size — Enter the header size in bytes, from 64 to 256. The default is 128.
Default 128 bytes
Command Mode
CONFIGURATION
Usage Information Use the no version of the command to reset the header size to the default value.
Example
OS10(conf)# sflow max-header-size 256
Supported Releases 10.3.0E or later
sow polling-interval
Sets the sFlow polling interval.
Syntax
sflow polling-interval interval-value
Parameter interval-value — Enter the interval value in sections, from 10 to 300. The default is 30.
Defaults 30
Command Mode CONFIGURATION
Usage Information
The polling interval for an interface is the number of seconds between successive samples of counters sent to the
collector. You can congure the duration for polled interface statistics. The no version of the command resets the
interval time to the default value.
Example
OS10(conf)# sflow polling-interval 200
Supported Releases 10.3.0E or later
912 sFlow