Setup Guide

Figure 9. Four-post threaded conguration

2 For each rail, attach the front and rear anges to the post anges with two user-supplied screws at each end, item 2.

S4048-ON installation

You can mount the switch in the 1U front-rack or 1U ush and center two-post congurations. The following is an example of a front-rack

conguration:

For the 1U ush and center two-post congurations, slide the switch into the rails in the same manner as the four-post congurations.

1U front-rack installation

You must congure the rails that are attached to the switch.

1 Attach the inner chassis members switch rails to the S4048–ON switch.

Item 3 shows the detail for the front stando with the locking tab.

S4048–ON installation