Concept Guide

2 Shut down the BGP neighbors corresponding to the IPv4 unicast address family using the following command:
shutdown address-family-ipv4-unicast
To enable or disable BGP neighbors corresponding to IPv4 multicast address family:
1 Enter the router bgp mode using the following command:
CONFIGURATION Mode
router bgp as-number
2 Shut down the BGP neighbors corresponding to IPv4 multicast address family using the following command:
ROUTER-BGP Mode
shutdown address-family-ipv4-multicast
To enable or disable BGP neighbors corresponding to the IPv6 unicast address family:
1 Enter the router bgp mode using the following command:
CONFIGURATION Mode
router bgp as-number
2 Shut down the BGP neighbors corresponding to the IPv6 unicast address family using the following command:
ROUTER-BGP Mode
shutdown address-family-ipv6-unicast
When you congure BGP, you must explicitly enable the BGP neighbors using the following commands:
neighbor {ip-address | peer-group name} remote-as as-number
neighbor {ip-address | peer-group-name} no shutdown
For more information on enabling BGP, see Enabling BGP.
When you use the shutdown all command in global conguration mode, this command takes precedence over the shutdown
address-family-ipv4-unicast
, shutdown address-family-ipv4-multicast, and shutdown address-family-
ipv6-unicast commands. Irrespective of whether the BGP neighbors are disabled earlier, the shutdown all command brings down
all the congured BGP neighbors.
When you issue the no shutdown all command, all the BGP neighbor neighbors are enabled. However, when you re-enable all the
BGP neighbors in global conguration mode, only the neighbors that were not in disabled state before the global shutdown come up.
Meaning, BGP neighbors corresponding to the IPv4 unicast or multicast address family and the IPv6 unicast address family that were
explicitly disabled before the global shutdown remains in disabled state. Use the no shutdown address-family-ipv4-unicast,
no shutdown address-family-ipv4-multicast, or no shutdown address-family-ipv6-unicast commands to
enable these neighbors.
NOTE
: This behavior applies to all BGP neighbors. Meaning, BGP neighbors that were explicitly disabled before global shutdown
also remain in disabled state. Enable these neighbors individually using the no shutdown command.
Route Map Continue
The BGP route map continue feature, continue [sequence-number], (in ROUTE-MAP mode) allows movement from one route-
map entry to a specic route-map entry (the sequence number).
If you do not specify a sequence number, the continue feature moves to the next sequence number (also known as an “implied continue”).
If a match clause exists, the continue feature executes only after a successful match occurs. If there are no successful matches, continue is
ignored.
Border Gateway Protocol (BGP)
245