Concept Guide

Table 37. Association Between Applications and Port Numbers
Application Name Port Number Client Server
SSH 22
Supported Supported
Sow-Collector 6343
Supported
SNMP 162 for SNMP Traps (client),
161 for SNMP MIB response (server)
Supported
NTP 123
Supported
DNS 53
Supported
FTP 20/21
Supported Supported
Syslog 514
Supported
Telnet 23
Supported Supported
TFTP 69
Supported
Radius 1812,1813
Supported
Tacacs 49
Supported
HTTP 80 for httpd
443 for secure httpd
8008 HTTP server port for confd application
8888 secure HTTP server port for confd
application
Supported
If you
congure a source interface is for any EIS management application, EIS might not coexist with that interface and the behavior is
undened in such a case. You can congure the source interface for the following applications: FTP, ICMP (ping and traceroute utilities),
NTP, RADIUS, TACACS, Telnet, TFTP, syslog, and SNMP traps. Out of these applications, EIS can coexist with only syslog and SNMP traps
because these applications do not require a response after a packet is sent.
The switch also processes user-specied port numbers for applications such as RADIUS, TACACS, SSH, and sFlow. The OS maintains a list
of congured management applications and their port numbers. You can congure two default routes, one congured on the management
port and the other on the front-end port.
Two tables, namely, Egress Interface Selection routing table and default routing table, are maintained. In the preceding table, the columns
Client and Server indicate that the applications can act as both a client and a server within the switch. The Management Egress Interface
Selection table contains all management routes (connected, static and default route). The default routing table contains all management
routes (connected, static and default route) and all front-end port routes.
Enabling and Disabling Management Egress Interface Selection
You can enable or disable egress-interface-selection using the management egress-interface-selection command.
NOTE
: Egress Interface Selection (EIS) works only with IPv4 routing.
408 Internet Group Management Protocol (IGMP)