Concept Guide
The default is 1.
Example of Conguring the Minimum Oper Up Links in a Port Channel
DellEMC#config t
DellEMC(conf)#int po 1
DellEMC(conf-if-po-1)#minimum-links 5
DellEMC(conf-if-po-1)#
Adding or Removing a Port Channel from a VLAN
As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a VLAN, place the port channel in
Layer 2 mode (by using the switchport command).
To add or remove a VLAN port channel and to view VLAN port channel members, use the following commands.
• Add the port channel to the VLAN as a tagged interface.
INTERFACE VLAN mode
tagged port-channel id number
An interface with tagging enabled can belong to multiple VLANs.
• Add the port channel to the VLAN as an untagged interface.
INTERFACE VLAN mode
untagged port-channel id number
An interface without tagging enabled can belong to only one VLAN.
• Remove the port channel with tagging enabled from the VLAN.
INTERFACE VLAN mode
no tagged port-channel id number
or
no untagged port-channel id number
• Identify which port channels are members of VLANs.
EXEC Privilege mode
show vlan
Conguring VLAN Tags for Member Interfaces
To congure and verify VLAN tags for individual members of a port channel, perform the following:
1 Congure VLAN membership on individual ports
INTERFACE mode
DellEMC(conf-if)#vlan tagged 2,3-4
2 Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interface
INTERFACE mode
DellEMC(conf-if)#switchport
3 Verify the manually congured VLAN membership (show interfaces switchport interface command).
434
Interfaces