Concept Guide

• Apply a Redirect-list to an Interface using a Redirect-group
PBR Exceptions (Permit)
To create an exception to a redirect list, use thepermit command. Exceptions are used when a forwarding decision should be based on
the routing table rather than a routing policy.
The Dell EMC Networking OS assigns the rst available sequence number to a rule congured without a sequence number and inserts the
rule into the PBR CAM region next to the existing entries. Because the order of rules is important, ensure that you congure any necessary
sequence numbers.
Never apply the permit statement because the redirect list covers all source and destination IP addresses.
ip redirect-list rcl0
seq 5 redirect 2.2.2.2 ip any any
seq 10 permit ip host 3.3.3.3 any
To ensure the permit permit statement or PBR exception is eective, use a lower sequence number, as shown:
ip redirect-list rcl0
seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Create a Redirect List
To create a redirect list, use the following commands.
Create a redirect list by entering the list name.
CONFIGURATION mode
ip redirect-list redirect-list-name
redirect-list-name: 16 characters.
To delete the redirect list, use the no ip redirect-list command.
The following example creates a redirect list by the name of xyz.
DellEMC(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
DellEMC(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
To set the rules for the redirect list, use the following command. You can enter the command multiple times and create a sequence of
redirect rules. Use the seq nn redirect version of the command to organize your rules.
Congure a rule for the redirect list.
CONF-REDIRECT-LIST mode
seq {number} redirect {ip-address | tunnel tunnel-id} [track <obj-id>}{ip-protocol-number |
protocol-type [bit]} {source mask | any | host ip-address}{destination mask | any | host ip-
address}
Policy-based Routing (PBR)
723