Concept Guide

Conguring a destination session
Following are the steps for conguring a destination session on a switch.
You can congure the below steps on other destination switches to congure additional destination ports for this RPM session.
1 Congure the destination session for RPM.
CONFIGURATION mode
monitor session session-id
2 Associate the Layer 2 VLAN used to transport monitored trac with this destination session.
MONITOR SESSION mode
source remote-vlan vlan-id destination interface direction {rx | tx | both}
3 (Optional) Congure destination ports so that the VLAN tag is added to the monitored trac.
MONITOR SESSION mode
tagged destination interface
To congure destination ports as untagged ports, enter the untagged destinationcommand.
Conguration Example of Remote Port Mirroring
This example provides a sample conguration of remote port mirroring (RPM) on a source switch, an intermediate switch, and a destination
switch based on the following illustration.
Figure 108. RPM Conguration
Following are the port numbers referred in the above illustration:
• 1 is tengigabitethernet 1/1
• 2 is tengigabitethernet 1/2
• 4 is tengigabitethernet 1/4
• 5 is tengigabitethernet 1/5
• 7 is tengigabitethernet 1/7
758
Port Monitoring