Concept Guide

• hmac-sha2-256
The default HMAC algorithms are the following:
• hmac-sha2-256
• hmac-sha1
• hmac-sha1-96
• hmac-md5
• hmac-md5-96
When FIPS is enabled, the default HMAC algorithm is hmac-sha2-256,hmac-sha1,hmac-sha1-96.
Example of Conguring a HMAC Algorithm
The following example shows you how to congure a HMAC algorithm list.
DellEMC(conf)# ip ssh server mac hmac-sha1-96
Conguring the SSH Server Cipher List
To congure the cipher list supported by the SSH server, use the ip ssh server cipher cipher-list command in CONFIGURATION
mode.
cipher-list-: Enter a space-delimited list of ciphers the SSH server will support.
The following ciphers are available.
• 3des-cbc
• aes128-cbc
• aes192-cbc
• aes256-cbc
• aes128-ctr
• aes192-ctr
• aes256-ctr
The default cipher list is aes256-ctr, aes256-cbc, aes192-ctr, aes192-cbc, aes128-ctr, aes128-cbc, 3des-cbc.
Example of Conguring a Cipher List
The following example shows you how to congure a cipher list.
DellEMC(conf)#ip ssh server cipher 3des-cbc aes128-cbc aes128-ctr
Conguring DNS in the SSH Server
Dell EMC Networking provides support to enable the DNS in SSH server conguration for host-based authentication. You can specify
whether the SSH Server should look up the remote host name and check whether the resolved host name for the remote IP address maps
to the same IP address. By default, the DNS in the SSH server conguration is disabled.
To enable the DNS in the SSH server conguration, use the following command.
• Enable the DNS in the SSH server conguration.
CONFIGURATION mode
Security
887