Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

1061

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

8.3.12.0 Introduced on the S4810.

8.4.1.0 Introduced.

Usage Information

Use this command to create an object that tracks the line-protocol state of a Layer 2 interface by monitoring its

operational status (UP or DOWN).

When the link-level status goes down, the tracked object status is considered to be DOWN; if the link-level status

is up, the tracked object status is considered to be UP.

Commands

• show track – display information about tracked objects, including configuration, current state, and clients

which track the object.

• track interface ip routing – configure object tracking on the routing status of an IPv4 Layer 3 interface.

track ip host reachability

Configure object tracking on the reachability of an IPv4 host.

Syntax

track object-id ip host host-ip-address/prefix-len reachability [vrf vrf-name]

To return to the default setting, use the no track object-id command.

Parameters

object-id

Enter the ID number of the tracked object. The range is 1 to 500.

ip-address/

prefix-len

Enter an IPv4 address in dotted decimal format. The valid IPv4 prefix lengths are from /0

to /32.

vrf

vrf-name

(Optional) You can configure a VPN routing and forwarding (VRF) instance to specify the

virtual routing table to which the tracked route belongs.

Defaults None

Command Modes CONFIGURATION