Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information
Setting a priority of 0 makes the router ineligible for election as a designated router or backup designated router.
Use this command for interfaces connected to multi-access networks, not point-to-point networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface.
S4048–ON
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval command.
Parameters
seconds Enter the number of seconds as the interval between retransmission. The range is from 1
to 3600. The default is 5 seconds.
This interval must be greater than the expected round-trip time for a packet to travel
between two routers.
Defaults 5 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Open Shortest Path First (OSPFv2 and OSPFv3) 1103