Administrator Guide

Version Description
7.7.1.0 Introduced on the E-Series.
Related
Commands
• ip redirect-list – enable an IP Redirect List.
ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command
multiple times.
Syntax
ip redirect-group redirect-list-name test [l2–switch]
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
redirect-list-name Enter the name of a configured redirect list.
l2–switch Enter the keyword l2–switch to enable PBR on Layer2 (switched) traffic.
Defaults None
Command Modes INTERFACE (conf-if-vl-)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced the l2–switch attribute.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of configured
rules. These rules includes the next-hop IP address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise, the normal routing
table is used to forward traffic. When a redirect-group is applied to an interface and the next-hop is reachable, the
rules are added into the PBR CAM region. When incoming traffic hits an entry in the CAM, the traffic is redirected
to the corresponding next-hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
The Layer2 PBR option matches the layer2 traffic flow. If you un-configure this option, then the Layer2 traffic is
not matched. You can apply the l2–switch option to redirect Layer2 traffic only on a VLAN interface. This
VLAN interface must be configured with an IP address for ARP resolution.
1150 Policy-based Routing (PBR)