Administrator Guide

Version Description
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show monitor session 1
SessID Source Destination Dir Mode Source IP Dest
IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
1 Te 1/2 remote-ip rx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
DellEMC# show monitor session
SessID Source Destination Dir Mode Source IP Dest
IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
1 Te 1/2 remote-ip rx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
Example (show
monitor session
access-list)
The following is an example output of the show monitor session access-list command.
DellEMC#sho monitor session 13 access-list
Monitor session – 13
Interface Direction Mirror-access-list
--------- --------- ------------------
Te 1/1 rx mtacl
mtv6acl(ipv6)
Related
Commands
• monitor session — creates a monitoring session.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show running-config monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range from 0 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
Port Monitoring 1205