Administrator Guide

Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the following keywords and slot/
port or number information:
• For a VLAN interface, enter the keyword vlan followed by the slot/port number.
• For a Port Channel interface, enter the keyword port-channel followed by a
number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display the access-lists that are
configured on either the default or non-default VRFs.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.5.1.0 Added support for the 4-port 40G line cards on the E-Series.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}} [count [bytes] | log] [dscp value] [ecn
value] [fragments] [monitor] [no-drop] [order]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no deny {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the packet was
sent.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address only.
192 Access Control Lists (ACL)