Administrator Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Related
Commands
• deny bandwidth – link band width extended-community attribute as the matching criteria to deny incoming or
outgoing traffic.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Border Gateway Protocol 405