Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

401

402

403

404

405

406

407

408

409

410

Version Description

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/peer-group outbound

route-map is set as internal.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage Information

You can use the redistribute command to advertise the IGP cost as the MED on redistributed routes. When

you set the route-map with metric-type internal and apply outbound to an EBGP peer/peer-group, the advertised

routes corresponding to those peer/peer-groups have the IGP cost set as MED.

When you enter the redistribute isis process-id command without any other parameters, Dell EMC

Networking OS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does

not support this feature.

router bgp

To configure and enable BGP, enter ROUTER BGP mode.

Syntax

router bgp as-number

To disable BGP, use the no router bgp as-number command.

Parameters

as-number

Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295 (4

byte), or from 0.1 to 65535.65535 (dotted format).

Defaults Not enabled.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.