Administrator Guide

Version Description
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no neighbor is
specified, debug is turned on for all neighbors.
ipv6 prefix-list
Configure an IPv6 prefix list.
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant DellEMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-reconfiguration
inbound
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to start storing inbound routing
updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound routing
updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
452 Border Gateway Protocol