Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
Usage Information
This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes down, the other
LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the
other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For more information,
see the “Port Channel” section in the Dell EMC Networking OS Configuration Guide.
Related Command
• group — group two LAGs in a supergroup (“fate-sharing group”).
• show interfaces port-channel — display information on configured Port Channel groups.
show config
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
DellEMC(conf-if-po-1)# show config
!
interface Port-channel 1
no ip address
shutdown
DellEMC(conf-if-po-1)#
734 Interfaces