Administrator Guide

Example
DellEMC# show crypto ipsec transform-set
Transform-Set Name : dallas
Transform-Set refCnt : 0
AH Transform :
ESP Auth Transform :
ESP Encry Transform : 3des
DellEMC#
show crypto ipsec policy
Display the crypto policy configuration.
Syntax
show crypto ipsec policy
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(1.0) Introduced on the Z9500.
Example
DellEMC(conf-crypto-policy)# do show crypto ipsec policy
Policy name : pol1
Policy refcount : 0
Sequence Num : 1
SA Mode : IPSEC-MANUAL
Transform-Set Name :
Peer IP Address :
Inbound AH SPI : 0
Inbound ESP Auth SPI : 0
Inbound ESP Encry SPI : 0
Inbound AH Key : [0]::
Inbound ESP Auth Key : [0]::
Inbound ESP Encry Key : [0]::
Outbound AH SPI : 0
Outbound ESP Auth SPI : 0
Outbound ESP Encry SPI: 0
Outound AH Key : [0]::
Outound ESP Auth Key : [0]::
Outound ESP Encry Key : [0]::
Match sequence Num : 2
Protocol type : tcp
IP or IPv6 : IP
Source address : 1.1.1.1
Source mask : /32
Source port : 0
Destination address : 1.1.1.2
Destination mask : /32
Destination port : 23
source-interface name :
source-interface num :
750
Internet Protocol Security (IPSec)