Administrator Guide

multicast Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE: Use this option if you want multicast functionality in an L2 VLAN
without IGMP protocols.
output interface For a unicast MAC address, enter the keyword output then one of the following
interfaces for which traffic is forwarded:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port channel interface, enter the keywords port-channel then a number.
output-range
interface
For a multicast MAC address, enter the keyword output-range then one of the
following interfaces to indicate a range of ports for which traffic is forwarded:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port channel interface, enter the keywords port-channel then a number.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for output range parameter for S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Example (Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 1/2 vlan 2}
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range Te
1/2, Te 1/3}
Related
Commands
• show mac-address-table — display the MAC address table.
Layer 2 925