Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048T-ON

961

962

963

964

965

966

967

968

969

970

Parameters

tx Enter the keyword tx to set the mode to transmit.

rx Enter the keyword rx to set the mode to receive.

Defaults Both transmit and receive.

Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series.

Commands

• protocol lldp (Configuration) — enable LLDP globally.

• show lldp neighbors — display the LLDP neighbors.

multiplier

Set the multiple of the hello timer before LLDP declares the interface dead.

Syntax

multiplier number

To return to the default, use the no multiplier command.

Parameters

integer

Enter the number of consecutive misses before the LLDP declares the interface dead.

The range is from 2 to 10.

Defaults 4