Users Guide

Displaying BFD for BGP Information
You can display related information for BFD for BGP.
To display information about BFD for BGP sessions on a router, use the following commands and refer to the following examples.
• Verify a BFD for BGP configuration.
EXEC Privilege mode
show running-config bgp
• Verify that a BFD for BGP session has been successfully established with a BGP neighbor. A line-by-line listing of established BFD
adjacencies is displayed.
EXEC Privilege mode
show bfd neighbors [interface] [detail]
• Check to see if BFD is enabled for BGP connections.
EXEC Privilege mode
show ip bgp summary
• Displays routing information exchanged with BGP neighbors, including BFD for BGP sessions.
EXEC Privilege mode
show ip bgp neighbors [ip-address]
The following example shows verifying a BGP configuration.
R2# show running-config bgp
!
router bgp 2
neighbor 1.1.1.2 remote-as 1
neighbor 1.1.1.2 no shutdown
neighbor 2.2.2.2 remote-as 1
neighbor 2.2.2.2 no shutdown
neighbor 3.3.3.2 remote-as 1
neighbor 3.3.3.2 no shutdown
bfd all-neighbors
The following example shows viewing all BFD neighbors.
R2# show bfd neighbors
* - Active session role
Ad Dn - Admin Down
B - BGP
C - CLI
I - ISIS
O - OSPF
R - Static Route (RTM)
M - MPLS
V - VRRP
LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
* 1.1.1.3 1.1.1.2 Te 6/1 Up 100 100 3 B
* 2.2.2.3 2.2.2.2 Te 6/2 Up 100 100 3 B
* 3.3.3.3 3.3.3.2 Te 6/3 Up 100 100 3 B
The following example shows viewing BFD neighbors with full detail.
The bold lines show the BFD session parameters: TX (packet transmission), RX (packet reception), and multiplier (maximum number of
missed packets).
R2# show bfd neighbors detail
Session Discriminator: 9
Neighbor Discriminator: 10
Local Addr: 1.1.1.3
Local MAC Addr: 00:01:e8:66:da:33
Remote Addr: 1.1.1.2
Remote MAC Addr: 00:01:e8:8a:da:7b
Int: TenGigabitEthernet 6/1
State: Up
136
Bidirectional Forwarding Detection (BFD)