Users Guide

Configuring Lossless Queues
DCB also supports the manual configuration of lossless queues on an interface when PFC mode is disabled in a DCB map, apply the map
on the interface. The configuration of no-drop queues provides flexibility for ports on which PFC is not needed, but lossless traffic should
egress from the interface.
Configuring no-drop queues is applicable only on the interfaces which do not need PFC.
Example:
Port A —> Port B
Port C —> Port B
PFC no-drop queues are configured for queues 1, 2 on Port B. PFC capability is enabled on priorities 3, 4 on PORT A and C.
Port B acting as Egress
During the congestion, [traffic pump on priorities 3 and 4 from PORT A and PORT C is at full line rate], PORT A and C send out the PFCs
to rate the traffic limit. Egress drops are not observed on Port B since traffic flow on priorities is mapped to loss less queues.
Port B acting as Ingress
If the traffic congestion is on PORT B , Egress DROP is on PORT A or C, as the PFC is not enabled on PORT B.
Refer the following configuration for queue to dot1p mapping:
Dell(conf)#do show qos dot1p-queue-mapping
Dot1p Priority : 0 1 2 3 4 5 6 7 -> On ingress interfaces[Port A and C] we used the
PFC on priority level.
Queue : 0 0 0 1 2 3 3 3 -> On Egress interface[Port B] we used no-drop
queues.
Lossless traffic egresses out the no-drop queues. Ingress 802.1p traffic from PFC-enabled peers is automatically mapped to the no-drop
egress queues.
When configuring lossless queues on a port interface, consider the following points:
• By default, no lossless queues are configured on a port.
• A limit of two lossless queues is supported on a port. If the number of lossless queues configured exceeds the maximum supported
limit per port (two), an error message is displayed. Reconfigure the value to a smaller number of queues.
• If you configure lossless queues on an interface that already has a DCB map with PFC enabled (pfc on), an error message is displayed.
Table 17. Configuring Lossless Queues on a Port Interface
Step Task Command Command Mode
1 Enter INTERFACE Configuration mode.
interface
{tengigabitEthernet slot/
port [/subport] |
fortygigabitEthernet slot/
port}
CONFIGURATION
2
Open a DCB map and enter DCB map configuration mode.
dcb-map name
INTERFACE
3
Disable PFC.
no pfc mode on
DCB MAP
4
Return to interface configuration mode.
exit
DCB MAP
5
Apply the DCB map, created to disable the PFC operation,
on the interface
dcb-map {name | default}
INTERFACE
6
Configure the port queues that still function as no-drop
queues for lossless traffic. For the dot1p-queue
assignments.
The maximum number of lossless queues globally
supported on a port is 2.
pfc no-drop
queuesqueue-range
INTERFACE
Data Center Bridging (DCB) 219