Users Guide

Table 19. Displaying DCB Configurations (continued)
Command Output
To clear PFC TLV counters, use the clear pfc counters
interface port-type slot/port command.
show interface port-type pfc statistics
Displays counters for the PFC frames received and transmitted (by
dot1p priority class) on an interface.
show interface port-type ets {summary |
detail}
Displays the ETS configuration applied to egress traffic on an
interface, including priority groups with priorities and bandwidth
allocation.
To clear ETS TLV counters, enter the clear ets counters
interface port-type slot/port command.
show interface port-type DCBx detail
Plays the DCBx configuration on an interface.
show stack-unit {0-11 | all} stack ports all
pfc details
Displays the PFC configuration applied to ingress traffic, including
priorities and link delay.
show stack-unit {0-11 | all} stack ports all
ets details
Displays the ETS configuration applied to ingress traffic on stack-
links, including priorities and link delay.
The following example shows the show dot1p-queue mapping command.
Dell(conf)# show qos dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 0 0 0 1 2 3 3 3
The following example shows the show dcb command.
Dell# show dcb
stack-unit 2 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
The following example shows the show qos priority-groups command.
Dell#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2
The following example shows the output of the show qos dcb-map test command.
Dell#show qos dcb-map test
-----------------------
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3 4
The following example shows the show interfaces pfc summary command.
Dell# show interfaces tengigabitethernet 1/4 pfc summary
Interface TenGigabitEthernet 1/4
Admin mode is on
Admin is enabled
Remote is enabled, Priority list is 4
234
Data Center Bridging (DCB)