Users Guide

ROUTER OSPF
ROUTER OSPFV3
ROUTER RIP
SPANNING TREE
SUPPORTASSIST
TRACE-LIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
uBoot
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the
command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit command which moves
you up one command mode level.
NOTE: Sub-CONFIGURATION modes all have the letters conf in the prompt with more modifiers to identify the mode
and slot/port[/subport] information.
Table 1. Dell Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC
Dell>
Access the router through the console or
terminal line.
EXEC Privilege
Dell#
• From EXEC mode, enter the enable
command.
• From any other mode, use the end
command.
CONFIGURATION
Dell(conf)#
• From EXEC privilege mode, enter the
configure command.
• From every mode except EXEC and
EXEC Privilege, enter the exit
command.
NOTE: Access all of the following
modes from CONFIGURATION
mode.
AS-PATH ACL
Dell(config-as-path)# ip as-path access-list
10 Gigabit Ethernet Interface
Dell(conf-if-te-1/1)#
interface (INTERFACE modes)
40 Gigabit Ethernet Interface
Dell(conf-if-fo-1/52)#
interface (INTERFACE modes)
Interface Group
Dell(conf-if-group)# interface(INTERFACE modes)
Interface Range
Dell(conf-if-range)#
interface (INTERFACE modes)
Loopback Interface
Dell(conf-if-lo-0)#
interface (INTERFACE modes)
Management Ethernet Interface
Dell(conf-if-ma-1/1)#
interface (INTERFACE modes)
Null Interface
Dell(conf-if-nu-0)#
interface (INTERFACE modes)
Port-channel Interface
Dell(conf-if-po-1)#
interface (INTERFACE modes)
Tunnel Interface
Dell(conf-if-tu-1)#
interface (INTERFACE modes)
VLAN Interface
Dell(conf-if-vl-1)#
interface (INTERFACE modes)
STANDARD ACCESS-LIST
Dell(config-std-nacl)#
ip access-list standard (IP
ACCESS-LIST Modes)
32 Configuration Fundamentals