Users Guide

To view a dampening summary for the entire system, use the show interfaces dampening summary command from EXEC
Privilege mode.
Dell# show interfaces dampening summary
20 interfaces are configured with dampening. 3 interfaces are currently suppressed.
Following interfaces are currently suppressed:
Te 1/2
Te 3/1
Te 4/2
Dell#
Clearing Dampening Counters
To clear dampening counters and accumulated penalties, use the following command.
• Clear dampening counters.
clear dampening
Dell# clear dampening interface Te 1/1
Dell#show interfaces dampening Tengigabitethernet 1/1
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Te 1/1 Up 0 0 1 2 3 4
Dell#
Link Dampening Support for XML
View the output of the following show commands in XML by adding | display xml to the end of the command.
• show interfaces dampening
• show interfaces dampening summary
• show interfaces interface slot/port[/subport]
Configure MTU Size on an Interface
In Dell Networking OS, Maximum Transmission Unit (MTU) is defined as the entire Ethernet packet (Ethernet header + FCS + payload).
The link MTU is the frame size of a packet, and the IP MTU size is used for IP fragmentation. If the system determines that the IP packet
must be fragmented as it leaves the interface, Dell Networking OS divides the packet into fragments no bigger than the size set in the ip
mtu command.
NOTE:
Because different networking vendors define MTU differently, check their documentation when planning MTU
sizes across a network.
The following table lists the range for each transmission media.
Transmission
Media
MTU Range (in bytes)
Ethernet
592-9216 = link MTU
576-9398 = IP MTU
Link Bundle Monitoring
Monitoring linked LAG bundles allows traffic distribution amounts in a link to be monitored for unfair distribution at any given time. A
threshold of 60% is defined as an acceptable amount of traffic on a member link. Links are monitored in 15-second intervals for three
consecutive instances. Any deviation within that time sends Syslog and an alarm event generates. When the deviation clears, another
Syslog sends and a clear alarm event generates.
The link bundle utilization is calculated as the total bandwidth of all links divided by the total bytes-per-second of all links. If you enable
monitoring, the utilization calculation is performed when the utilization of the link-bundle (not a link within a bundle) exceeds 60%.
To enable and view link bundle monitoring, use the following commands.
Interfaces
349