Users Guide
For more information about Proxy ARP, refer to RFC 925, Multi-LAN Address Resolution, and RFC 1027, Using ARP to Implement
Transparent Subnet Gateways.
Configuration Tasks for ARP
For a complete listing of all ARP-related commands, refer to the Dell Networking OS Command Line Reference Guide.
Configuration tasks for ARP include:
• Configuring Static ARP Entries (optional)
• Enabling Proxy ARP (optional)
• Clearing ARP Cache (optional)
• ARP Learning via Gratuitous ARP
• ARP Learning via ARP Request
• Configuring ARP Retries
Configuring Static ARP Entries
ARP dynamically maps the MAC and IP addresses, and while most network host support dynamic mapping, you can configure an ARP
entry (called a static ARP) for the ARP cache.
To configure a static ARP entry, use the following command.
• Configure an IP address and MAC address mapping for an interface.
CONFIGURATION mode
arp vrf vrf-name ip-address mac-address interface
○ vrf vrf-name: use the VRF option to configure a static ARP on that particular VRF.
○ ip-address: IP address in dotted decimal format (A.B.C.D).
○ mac-address: MAC address in nnnn.nnnn.nnnn format.
○ interface: enter the interface type slot/port information. For 10G interfaces, enter the slot/port information.
These entries do not age and can only be removed manually. To remove a static ARP entry, use the no arp ip-address command.
To view the static entries in the ARP cache, use the show arp static command in EXEC privilege mode.
Dell#show arp
Protocol Address Age(min) Hardware Address Interface VLAN CPU
--------------------------------------------------------------------------------
Internet 10.1.2.4 17 08:00:20:b7:bd:32 Ma 1/1 - CP
Dell#
Enabling Proxy ARP
By default, Proxy ARP is enabled. To disable Proxy ARP, use the no proxy-arp command in the interface mode.
To re-enable Proxy ARP, use the following command.
• Re-enable Proxy ARP.
INTERFACE mode
ip proxy-arp
To view if Proxy ARP is enabled on the interface, use the show config command in INTERFACE mode. If it is not listed in the show
config command output, it is enabled. Only non-default information is displayed in the show config command output.
Clearing ARP Cache
To clear the ARP cache of dynamically learnt ARP information, use the following command.
• Clear the ARP caches for all interfaces or for a specific interface by entering the following information.
EXEC privilege
366
IPv4 Routing