Users Guide

• Prefix Renumbering — Useful in transparent renumbering of hosts in the network when an organization changes its service
provider.
NOTE: As an alternative to stateless autoconfiguration, network hosts can obtain their IPv6 addresses using the
dynamic host control protocol (DHCP) servers via stateful auto-configuration.
NOTE: Dell Networking OS provides the flexibility to add prefixes on Router Advertisements (RA) to advertise
responses to Router Solicitations (RS). By default, RA response messages are sent when an RS message is received.
Dell Networking OS manipulation of IPv6 stateless autoconfiguration supports the router side only. Neighbor discovery (ND) messages are
advertised so the neighbor can use this information to auto-configure its address. However, received ND messages are not used to create
an IPv6 address.
NOTE: Inconsistencies in router advertisement values between routers are logged per RFC 4861. The values checked for
consistency include:
• Cur Hop limit
• M and O flags
• Reachable time
• Retrans timer
• MTU options
• Preferred and valid lifetime values for the same prefix
Only management ports support stateless auto-configuration as a host.
The router redirect functionality in the neighbor discovery protocol (NDP) is similar to IPv4 router redirect messages. NDP uses ICMPv6
redirect messages (Type 137) to inform nodes that a better router exists on the link.
IPv6 Headers
The IPv6 header has a fixed length of 40 bytes. This fixed length provides 16 bytes each for source and destination information and 8
bytes for general header information.
The IPv6 header includes the following fields:
• Version (4 bits)
• Traffic Class (8 bits)
• Flow Label (20 bits)
• Payload Length (16 bits)
• Next Header (8 bits)
• Hop Limit (8 bits)
• Source Address (128 bits)
• Destination Address (128 bits)
IPv6 provides for extension headers. Extension headers are used only if necessary. There can be no extension headers, one extension
header or more than one extension header in an IPv6 packet. Extension headers are defined in the Next Header field of the preceding IPv6
header.
374
IPv6 Routing