Users Guide
The output of the show file-systems command in the following example shows the total capacity, amount of free memory, file
structure, media type, read/write privileges for each storage device in use.
Dell#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
520962048 213778432 dosFs2.0 USERFLASH rw flash:
127772672 21936128 dosFs2.0 USERFLASH rw slot0:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
You can change the default file system so that file management commands apply to a particular device or memory.
To change the default directory, use the following command.
• Change the default directory.
EXEC Privilege mode
cd directory
Enabling Software Features on Devices Using a
Command Option
The capability to activate software applications or components on a device using a command is supported on this platform.
Starting with Release 9.4(0.0), you can enable or disable specific software features or applications that need to run on a device by using a
command attribute in the CLI interface. This enables effective, streamlined management and administration of applications and utilities
that run on a device. You can employ this capability to perform an on-demand activation, or turn-off a software component or protocol. A
feature configuration file generated for each image contains feature names, and denotes if this enabling or disabling method is available.
You can enable or disable the VRF application globally across the system by using this capability.
Activate the VRF application on a device by using the feature vrf command in CONFIGURATION mode.
NOTE: The no feature vrf command is not supported on any of the platforms.
To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI interface, use the following
command. You must enable the VRF feature before you can configure its related attributes.
Dell(conf)# feature vrf
Based on if the VRF feature is identified as supported in the Feature Configuration file, configuration command feature vrf becomes
available for usage. This command is stored in the running-configuration and precedes all other VRF-related configurations.
To display the state of Dell Networking OS features:
Dell# show feature
Example of show feature output
For a particular target where VRF is enabled, the show output is similar to the following:
Feature State
------------------------
VRF Enabled
View Command History
The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes these
messages to a dedicated trace log buffer.
The system generates a trace message for each executed command. No password information is saved to the file.
To view the command-history trace, use the show command-history command.
Example of the show command-history Command
Dell#show command-history
[12/5 10:57:8]: CMD-(CLI):service password-encryption
Getting Started
49