Users Guide

Apply a Redirect-list to an Interface using a Redirect-
group
IP redirect lists are supported on physical interfaces as well as virtual local area network (VLAN) and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination
port-channel is shut down, the traffic is dropped. However, the traffic redirected to the destination port-channel is
sometimes switched.
To apply a redirect list to an interface, use the following command. You can apply multiple redirect-lists can be applied to a redirect-group.
It is also possible to create two or more redirect-groups on one interface for backup purposes.
Apply a redirect list (policy-based routing) to an interface.
INTERFACE mode
ip redirect-group redirect-list-name
• redirect-list-name is the name of a redirect list to apply to this interface.
• FORMAT: up to 16 characters
To delete the redirect list from this interface, use the no ip redirect-group command.
In this example, the list xyz is applied to the tenGigabitEthernet 1/1 interface.
Example: Applying a Redirect-list to an Interface
Dell(conf-if-te-1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1)#
Example: Applying a Redirect-list to an Interface
Dell(conf-if-te-1/1)#ip redirect-group test
Dell(conf-if-te-1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/1)#
Dell(conf-if-gi-1/1)#ip redirect-group test
Dell(conf-if-gi-1/1)#ip redirect-group xyz
Dell(conf-if-gi-1/1)#show config
!
interface GigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-gi-1/1)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface. Dell
Networking OS has the capability to support multiple groups on an interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following commands.
1. View the redirect list configuration and the associated interfaces.
EXEC mode
show ip redirect-list redirect-list-name
2. View the redirect list entries programmed in the CAM.
EXEC mode
Policy-based Routing (PBR)
567