Users Guide

mixed-mode-stacking enable
The following message appears prompting you to confirm the configuration:
Enabling mixed-mode-stacking requires configuration save and reload to operate in
compatible with S4048-ON.
Do you want to reload? Proceed[confirm yes/no]:
2. Enter yes at this prompt and press the return key.
The following message appears prompting you to save the configuration:
System configuration has been modified. Save? [yes/no]:
3. Enter yes again and press the return key.
Verify a Stack Configuration
The light of the LED status indicator on the front panel of the stack identifies the unit’s role in the stack.
• Off indicates the unit is a stack member.
• The master LED is in OFF state for the standby unit.
• Solid green indicates the unit is the stack master (management unit).
Displaying the Status of Stacking Ports
To display the status of the stacking ports, including the topology, use the following command.
• Display the stacking ports.
EXEC Privilege mode
show system stack-ports
Dell#show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link
(Gb/s) Status Status
---------------------------------------------------------
1/53 2/53 42 up up
1/54 3/54 42 up up
2/53 1/53 42 up up
2/54 3/53 42 up up
3/53 2/54 42 up up
3/54 1/54 42 up up
Dell#
The following example shows the parameters for the management unit in the stack.
Dell#show system stack-unit 1
-- Unit 1 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S4810 - 52-port GE/TE/FG (SE)
Current Type : S4810 - 52-port GE/TE/FG (SE)
Master priority : 0
Hardware Rev : 3.0
Num Ports : 64
Up Time : 1 min, 14 sec
Dell Networking OS Version : 4810-8-3-12-1447
Jumbo Capable : yes
POE Capable : no
Boot Flash : 1.2.0.2
Memory Size : 2147483648 bytes
Temperature : 44C
Voltage : ok
Serial Number : H1DL104400018
Part Number : Rev
Vendor Id :
Date Code :
764
Stacking