Users Guide

To change the duration of the configurable timer, use the delay-restore command.
If you enable IGMP snooping, IGMP queries are also sent out on the VLT ports at this time allowing any receivers to respond to the queries
and update the multicast table on the new node.
This delay in bringing up the VLT ports also applies when the VLTi link recovers from a failure that caused the VLT ports on the secondary
VLT peer node to be disabled.
PIM-Sparse Mode Support on VLT
The designated router functionality of the PIM Sparse-Mode multicast protocol is supported on VLT peer switches for multicast sources
and receivers that are connected to VLT ports.
VLT peer switches can act as a last-hop router for IGMP receivers and as a first-hop router for multicast sources.
Figure 137. PIM-Sparse Mode Support on VLT
On each VLAN where the VLT peer nodes act as the first hop or last hop routers, one of the VLT peer nodes is elected as the PIM
designated router. If you configured IGMP snooping along with PIM on the VLT VLANs, you must configure VLTi as the static multicast
router port on both VLT peer switches. This ensures that for first hop routers, the packets from the source are redirected to the
designated router (DR) if they are incorrectly hashed. In addition to being first-hop or last -hop routers, the peer node can also act as an
intermediate router.
On a VLT-enabled PIM router, if any PIM neighbor is reachable through a Spanned Layer 3 (L3) VLAN interface, this must be the only
PIM-enabled interface to reach that neighbor. A Spanned L3 VLAN is any L3 VLAN configured on both peers in a VLT domain. This does
832
Virtual Link Trunking (VLT)