API Guide
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 deny AB20::1/128 ge 10
Supported
Release
10.3.0E or later
ipv6 prefix-list seq permit
Configures a filter to permit route filtering from a specified prefix-list.
Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
● name — (Optional) Enter the name of the IPv6 prefix-list.
● num — Enter the sequence number of the specified IPv6 prefix list.
● A::B/x — Enter the IPv6 address and mask in /prefix format (/x).
● ge — Enter to indicate the network address is greater than or equal to the range specified.
● le — Enter to indicate the network address is less than or equal to the range specified.
● prefix-len — Enter the prefix length.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 permit AB10::1/128 ge 30
Supported
Release
10.3.0E or later
mac access-group
Configures a MAC access group.
Syntax
mac access-group access-list-name {in | out}
Parameters
● access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
● in — Apply the ACL to incoming traffic.
● out — Apply the ACL to outgoing traffic.
Default Not configured
Command Mode
CONFIGURATION
CONTROL-PLANE
Usage
Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are
only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports.
The no version of this command resets the value to the default.
Example
OS10(config)# mac access-group maclist in
OS10(conf-mac-acl)#
Example
(Control-plane
ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# mac access-group maclist in
1144 Access Control Lists