API Guide

OS10(conf-pg-1/1/13)# exit
OS10(config)# interface ethernet 1/1/41:1
OS10(conf-if-eth1/1/41:1)#
View Ethernet unified port interface
OS10(config)# interface ethernet 1/1/41
OS10(conf-if-eth1/1/41:1)# show configuration
!
interface ethernet1/1/41:1
no shutdown
Z9264F-ON port-group profiles
On the Z9264F-ON switch, the port-group profiles determine the available front-panel Ethernet ports and supported breakout
interfaces. QSFP28 ports operate only in Ethernet mode. Use the port-group profile to configure breakout interfaces and
specify the port speed.
NOTE: The configuration steps to enable Ethernet interfaces on a Z9264F-ON port group are different than that of the
S4100-ON series. Follow the procedure described in this section to configure breakout interfaces on a Z9264F-ON switch.
Each pair of odd and even numbered ports is configured as a port group. For example:
hybrid-group profile Ports Mode
port-group1/1/1 restricted 1/1/1 Eth 10g-4x
1/1/2 Eth Disabled
port-group1/1/2 restricted 1/1/3 Eth 10g-4x
1/1/4 Eth Disabled
port-group1/1/3 restricted 1/1/5 Eth 10g-4x
1/1/6 Eth Disabled
.
.
.
port-group1/1/31 unrestricted 1/1/61 Eth 100g-1x
1/1/62 Eth 100g-1x
port-group1/1/32 unrestricted 1/1/63 Eth 100g-1x
1/1/64 Eth 100g-1x
On the Z9264F-ON switch, the available Ethernet interfaces in a port group depends on the currently configured port-group
profile. For details about the supported breakout modes in port-group profiles, see the profile CLI command.
To enable Ethernet interfaces:
1. Configure a Z9264F-ON port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range is from 1 to
32.
port-group node/slot/port-group
Interfaces
245