API Guide

OS Version: 10.5.1.0
Build Version: 10.5.1.0.123
Build Time: 2020-02-12T02:34:02+0000
System Type: Z9100-ON
Architecture: x86_64
Up Time: 04:40:37
Install firmware upgrade
You may need to upgrade the firmware components on an OS10 switch without upgrading the OS10 image. To upgrade firmware
components in a separate operation:
1. Download the OS10 firmware file from a server using the image download server-filepath/firmware-filename
command in EXEC mode; for example:
OS10# image download http://10.11.8.184/tftpboot/users/regr//neteng/okelani/files
/new/onie-firmware-x86_64-dellemc_s5200_c3538-r0.3.40.5.1-9.bin
2. Install the OS10 firmware file using the image install firmware-file-url command in EXEC mode, where
firmware-file is the name of the firmware file downloaded in Step 1; for example:
OS10# image install image://onie-firmware-x86_64-dellemc_s5200_c3538-r0.3.40.5.1-9.bin
To view the pending firmware upgrade, use the show image firmware command. To cancel a firmware installation and
remove any pending firmware upgrades, use the image cancel command.
3. Reload the switch in EXEC mode.
OS10# reload
Upgrade commands
boot system
Sets the boot partition to use for the next reboot.
Syntax
boot system {active | standby}
Parameters
● active — Reset the running partition as the next boot partition.
● standby — Set the standby partition as the next boot partition.
Default Active
Command Mode EXEC
Usage
Information
Use this command to configure the location of the OS10 image used to reload the software at boot time.
Use the show boot command to view the configured next boot image. This command applies
immediately and does not require the commit command.
Example
OS10# boot system standby
Supported
Releases
10.2.0E or later
image cancel
Cancels an image or firmware file download that is in progress.
Syntax
image cancel
Parameters None
Getting Started with Dell EMC SmartFabric OS10 37