API Guide

Table 19. Command Description

Command Description

:de14:2204:fff

:fe21:7fc9

ONLINE

BACKUP

MX9116n

SKYMX10

MXWV011

fde1:53ba:e9a0

:de14:2204:fff

:fe21:9f49

ONLINE

BACKUP

MX9116n

SKYMX02

MX9116N-A2#

xii. After completing the above step, upgrade the

next Networking I/O Module.

xiii. After all Fabric Switching Engines are updated, all

solution components (compute, chassis, and

fabric switching engine) in this entire process will

be updated. Power cycle the MX7000 chassis

after updating all applicable solution components.

Remote access

After you install or upgrade OS10 and log in, you can set up remote access to the OS10 command-line interface and the Linux

shell. Connect to the switch using the serial port. Serial port settings are 115200 baud, 8 data bits, and no parity.

Configure remote access

1. Configure the Management IP address.

2. Configure Management route.

3. Configure user name and password.

Configure Management IP address

To remotely access OS10, assign an IP address to the management port. Use the management interface for out-of-band (OOB)

switch management.

1. Configure the management interface from CONFIGURATION mode.

interface mgmt 1/1/1

2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.

no ip address dhcp

3. Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.

ip address A.B.C.D/mask

ipv6 address A:B/prefix-length

Getting Started with Dell EMC SmartFabric OS10