Connectivity Guide

NOTE: In S5148F-ON, when receive is turned on, it enables decoding of both LLFC and PFC
frames on that port.
• transmit — (Optional) Indicates the local port can send ow control packets to a remote device.
• on — (Optional) When used with receive, allows the local port to receive ow control trac. When used
with
transmit, allows the local port to send ow control trac to the remote device.
• off — (Optional) When used with receive, disables the remote device from sending ow control trac to
the local port. When used with transmit, disables the local port from sending ow control trac to the
remote device.
Default Disabled (off)
Command Mode INTERFACE
Usage Information The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# flowcontrol transmit on
Supported Releases 10.3.0E or later
hardware deep-buer-mode
Congures Deep Buer mode.
Syntax
hardware deep-buffer-mode
Parameters None
Defaults Disabled
Command Modes CONFIGURATION
Usage Information
Deep Buer mode conguration takes eect only after you save it in the startup conguration and reboot the
switch. The no version of this command disables Deep Buer mode.
Example
OS10(config)# hardware deep-buffer-mode
Supported Releases 10.4.3.0 or later
match
Congures match criteria for the QoS policy.
Syntax
match {cos cos-number | ip [access-group name name | dscp dscp-value |
precedence value] | ipv6 [access-group name name [set dscp dscp-value]] | mac
access-group acl-name | not [ip | cos] vlan vlan-id} [set dscp dscp-value]
Parameters
• cos cos—number — Enter a queue number for the CoS match criteria, from 0 to 7.
• ip — Enter the IPv4 match criteria.
• access-group name name — (Optional) Enter the IPv4 access-group name.
• dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ipv6 — Enter the IPv6 match criteria.
1000 Quality of service