Connectivity Guide

sensor-group (subscription-prole)
Assigns a sensor group with sampling interval to a subscription prole for streaming telemetry.
Syntax
sensor-group group-name sampling-interval
Parameters
• group-name — Enter the name for the sensor group. In release 10.4.3.0, only pre-congured sensor groups
are supported: bgp, bgp-peer, buffer, device, environment, interface, lag, and system.
• sampling-interval — Enter the interval in milliseconds used to collect data samples. The range is 0 to
4294967295. The default is 15000.
Default Not congured
Command mode SUBSCRIPTION-PROFILE
Usage information This command assigns the sensors from which data is collected for streaming telemetry to a subscription prole
and species the sampling rate. To add sensor groups to the subscription prole, re-enter the command. The
interface sensor group supports only physical and port-channel interfaces. The no version of this command
removes the sensor group from the subscription prole.
Example
OS10(conf-telemetry)# subscription-profile subscription-1
OS10(conf-telemetry-sp-subscription-1)# sensor-group bgp 30000
OS10(conf-telemetry-sp-subscription-1)# sensor-group environment 415000
Supported releases 10.4.3.0 or later
sensor-group (telemetry)
Congures a sensor group for streaming telemetry.
NOTE
: This command is not supported in release 10.4.3.0.
Syntax
sensor-group group-name
Parameters group-name — Enter the name of the sensor group. A maximum of 32 characters. You can enter the name of a
pre-congured sensor-group prole. Valid values are: bgp, bgp-peer, buffer, device, environment,
interface, lag, and system.
Default Not congured
Command mode TELEMETRY
Usage information A sensor group denes the YANG models from which data is collected and streamed to a destination. You can also
use pre-congured sensor group proles without specifying the YANG container path. In release 10.4.3.0, telemetry
supports only pre-congured sensor groups. The interface sensor group supports only physical and port-
channel interfaces. To view the YANG paths in a pre-congured sensor group, use the show telemetry
sensor-group
command.
Example
OS10(conf-telemetry)# sensor-group bgp
OS10(conf-telemetry-sg-bgp)#
Supported releases 10.4.3.0 or later
1138 Telemetry