Connectivity Guide

2 Congure L3 routing in INTERFACE mode. Add secondary to congure backup IP addresses.
ip address address [secondary]
3 Enable the interface for L3 trac transmission in INTERFACE mode.
no shutdown
L3 interface conguration
OS10(config)# interface ethernet 1/1/9
OS10(conf-if-eth1/1/9)# no switchport
OS10(conf-if-eth1/1/9)# ip address 10.10.1.92/24
OS10(conf-if-eth1/1/9)# no shutdown
View L3 conguration error
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24
% Error: remove Layer 2 configuration before assigning an IP
Fibre Channel interfaces
OS10 unied port groups support FC interfaces. A unied port group operates in Fibre Channel or Ethernet mode. To activate FC
interfaces, congure a port group to operate in Fibre Channel mode and specify the port speed. By default, FC interfaces are disabled.
S4148U-ON
On a S4148U-ON switch, FC interfaces are available in all port groups. The activated FC interfaces depend on the currently congured port
prole. For more information, see S4148U-ON port proles.
Figure 5. S4148U-ON unied port groups
1 Congure a unied port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the switch.
port-group node/slot/port-group
2 Activate the unied port group for FC operation in PORT-GROUP mode. The available FC modes depend on the switch.
mode fc {32g-4x | 32g-2x | 32g-1x | 16g-4x | 16g-2x | 8g-4x}
• 8g-4x — Split a unied port group into four 8 GFC interfaces.
• 16g-2x — Split a unied port group into two 16 GFC interfaces.
• 16g-4x — Split a unied port group into four 16 GFC interfaces.
• 32g-1x — Split a unied port group into one 32 GFC interface. A 1x-32G interface has a rate limit of 28G.
• 32g-2x — Split a unied port group into two 32 GFC interfaces.
• 32g-4x — Split a unied port group into four 32 GFC interfaces. Each 4x-32GE breakout interface has a rate limit of 25G.
3 Return to CONFIGURATION mode.
exit
4 Enter FC Interface mode to enable data transmission. Enter a single interface, a hyphen-separated range, or multiple interfaces
separated by commas.
interface fibrechannel node/slot/port[:subport]
152
Interfaces