Connectivity Guide

Congure load balancing
OS10(config)# load-balancing ip-selection destination-ip source-ip
Change hash algorithm
The load-balancing command selects the hash criteria applied to trac load balancing on port-channels. If you do not obtain even
trac distribution, use the hash-algorithm command to select the hash scheme for LAG. Rotate or shift the L2-bit LAG hash until you
achieve the desired trac distribution.
• Change the default (0) to another algorithm and apply it to LAG hashing in CONFIGURATION mode.
hash-algorithm lag crc
Change hash algorithm
OS10(config)# hash-algorithm lag crc
Congure interface ranges
Bulk interface conguration allows you to apply the same conguration to multiple physical or logical interfaces, or to display their current
conguration. An interface range is a set of interfaces that you apply the same command to.
You can use interface ranges for:
• Ethernet physical interfaces
• Port channels
• VLAN interfaces
A bulk conguration includes any non-existing interfaces in an interface range from the conguration.
You can congure a default VLAN only if the interface range being congured consists of only VLAN ports. When a conguration in one of
the VLAN ports fails, all the VLAN ports in the interface range are aected.
Create an interface range allowing other commands to be applied to that interface range using the interface range command.
Congure range of Ethernet addresses and enable them
OS10(config)# interface range ethernet 1/1/1-1/1/5
OS10(conf-range-eth1/1/1-1/1/5)# no shutdown
View the conguration
OS10(conf-range-eth1/1/1-1/1/5)# show configuration
!
interface ethernet1/1/1
no shutdown
switchport access vlan 1
!
interface ethernet1/1/2
no shutdown
switchport access vlan 1
!
interface ethernet1/1/3
no shutdown
switchport access vlan 1
!
interface ethernet1/1/4
no shutdown
switchport access vlan 1
!
interface ethernet1/1/5
Interfaces
159