Connectivity Guide

Default 0x08
Command Mode CONFIGURATION
Usage Information
You can congure only one PFC priority at a time. The no version of this command returns the conguration to
default value.
Example
OS10(config)# fcoe priority-bits 0x08
Supported Releases 10.4.0E(R3) or later
lldp tlv-select dcbxp-appln fcoe
Enables FCoE application TLV for an interface.
Syntax
lldp tlv-select dcbxp-appln fcoe
Parameter None
Default Enabled
Command Mode INTERFACE
Usage Information
The default priority value advertised in FCoE application TLV is 3. If the PFC conguration in an interface matches
3, then the FCoE application TLV is advertised as 3. Otherwise, FCoE application TLV is not advertised.
When you congure the application priority using fcoe priority-bits command, the congured value is
advertised in the TLV, which is not dependent on PFC conguration.
The no version of this command disables the FCoE application TLV.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbx-appln fcoe
Supported Releases 10.4.0E(R3) or later
show fcoe enode
Displays the details of ENodes connected to the switch.
Syntax
show fcoe enode [enode-mac-address]
Parameters enode-mac-address — (Optional) Enter the MAC address of ENode. This option displays details pertaining to
the specied ENode.
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show fcoe enode
Enode MAC Enode Interface VLAN FCFs Sessions
----------------- ---------------- ---- ---- --------
d4:ae:52:1b:e3:cd Po 20(Eth 1/1/3) 1001 1 1
Supported Releases 10.4.0E(R1) or later
Fibre Channel 249