Connectivity Guide

lldp tlv-select dot3tlv
Enables or disables the dot3 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot3tlv {macphy-config | max-framesize}
Parameters
• macphy-config — Enable the port VLAN ID TLV.
• max-framesize — Enable maximum frame size TLV.
Default Enabled
Command Mode INTERFACE
Usage Information The no version of this command disables TLV transmission.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select dot3tlv macphy-config
Supported Releases 10.2.0E or later
lldp transmit
Enables the transmission of LLDP packets on a specic interface.
Syntax
lldp transmit
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command disables the transmission of LLDP packets on a specic interface.
Example
OS10(conf-if-eth1/1/9)# lldp transmit
Supported Releases 10.2.0E or later
show lldp interface
Displays the LLDP information advertised from a specic interface.
Syntax
show lldp interface ethernet node/slot/port[:subport] [med | local—device]
Parameters
• ethernet node/slot/port[:subport] — Enter the Ethernet interface information.
• med — Enter the interface to view the MED information.
• local-device — Enter the interface to view the local-device information.
Default None
Command Mode EXEC
Usage Information Use the med parameter to view MED information for a specic interface. Use the local-device parameter to
view inventory details.
Layer 2 307