Connectivity Guide

The candidate conguration allows you to avoid introducing errors during an OS10 conguration session. You can make changes and then
check them before committing them to the active, running conguration on the network device.
To check dierences between the running conguration and the candidate conguration, use the show diff command. After comparing
the two, decide if you will commit the changes to the running conguration. To delete uncommitted changes, use the discard command.
•
Enter show ? from EXEC mode to view a list of commands to monitor a device.
OS10# show ?
acl-table-usage Show ACL table utilization
alarms Display all current alarm situation in the system
alias Show list of aliases
bfd Show bfd session commands
boot Show boot information
candidate-configuration Current candidate configuration
class-map Show QoS class-map configuration
clock Show the system date and time
command-history Show command history of the current user
control-plane Display control-plane related informations
copy-file Show file copy operation information
crypto Display cryptographic information
diag Show diagnostic information for port adapters/modules
diff Display differences between two configuration set
discovered-expanders discovered expanders info
dot1x Show dot1x information
environment Show the environmental information of the system
errdisable Show errdisable information
eula-consent Shows eula-consent for various modules
evpn Show Ethernet Virtual Private Network
exec-timeout Show the timeout value of CLI session (in seconds)
fcoe show fcoe
file Display file content in specified location
fips Show fips mode status
hardware Show hardware information
hash-algorithm Show hash algorithm information
hosts show information about DNS
image Show image information
interface Interface status and configuration
inventory Show the system inventory information
ip show IP commands
ipv6 Display IPv6 neighbor information
iscsi Show iscsi
lacp Show LACP information
license Show license and digital fulfillment related information
link-bundle-utilization Display the link-bundle utilization for the interfaces in the
bundle
lldp Show lldp
load-balance Show global traffic load-balance configuration
logging Show logging messages
login Show login parameters
mac MAC forwarding table
monitor Show port monitoring sessions
network-policy Show network policy
ntp NTP associations
nve Display NVE related info
parser-tree Show parser tree
policy-map Show policy-map information
port-channel LAG status and configuration
processes Show processes statistics
qos Show ingress or egress QoS configuration
queuing Show egress QoS counters
route-map Show route map information
running-configuration Current operating configuration
sessions Show active management sessions
sflow Show sflow
snmp Display all current snmp configuration
spanning-tree Show spanning tree information
startup-configuration Contents of startup configuration
Getting Started
51