Connectivity Guide

Parameters
• process-id—Enter an OSPFv3 process ID for a specic OSPFv3 process, from 1 to 65535.
• area-id—Enter the OSPFv3 area ID in dotted decimal A.B.C.D format or enter an area ID number, from 1 to
65535.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command removes an interface from an OSPFv3 area.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ipv6 ospf 10 area 1
Supported Releases 10.3.0E or later
ipv6 ospf authentication
Congures OSPFv3 authentication on an IPv6 interface.
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1} key}
Parameters
• null — Prevents area authentication from being inherited on the interface.
• ipsec spi number — Enter a unique security policy index number, from 256 to 4294967295.
• md5 — Enable MD5 authentication.
• sha1 — Enable SHA1 authentication.
• key — Enter the text string used by the authentication type.
Default IPv6 OSPF authentication is not congured on an interface.
Command Mode INTERFACE
Usage Information
• Before you enable IPsec authentication on an OSPFv3 interface, you must enable IPv6 unicast routing globally,
congure an IPv6 address and enable OSPFv3 on the interface, and assign it to an area.
• The SPI value must be unique to one IPsec authentication or encryption security policy on the router. You
cannot congure the same SPI value on another interface even if it uses the same authentication or encryption
algorithm.
• You cannot use an IPsec MD5 or SHA1 authentication type and the null setting at same time on an interface.
These settings are mutually exclusive.
• All neighboring OSPFv3 routers must share the key to exchange information. Only a non-encrypted key is
supported. For MD5 authentication, the non-encrypted key must be 32 plain hex digits. For SHA1
authentication, the non-encrypted key must be 40 hex digits. An encrypted key is not supported.
Example
OS10(config)# interface ethernet 1/1/6
OS10(conf-if-eth1/1/6)# ipv6 ospf authentication ipsec spi 400 md5
12345678123456781234567812345678
Supported Releases 10.4.0E(R1) or later
ipv6 ospf cost
Changes the cost associated with the OSPFv3 trac on an interface
Syntax
ipv6 ospf cost cost
578 Layer 3